Follow this procedure to configure dataone broadband connection for D-Link DSL-G604T modem.
1. Open your web browser
2. Open the link http://192.168.1.1/ from your browser. You will be prompted for username and password. If this is a new modem then following are the default username and password values.
Username: admin
Password: admin
3. Open the "Setup" tab and configure your connection as shown below.
PVC Settings
VPI: 0; VCI: 35
4. Note that username is "yourusername@dataone" and the corresponding account password. (There is no ".in" in the username).
5. Click apply.
6. Click the "Tools" tab. -> System Commands
7. Select "Save all" followed by "Restart"
Your web page will go blank and you might need to refresh and re-login after some time. (Approximately 1 min).
8. To check DSL connection status you can open "Status" tab followed by "Connection Status"
How to set the D-Link DSL-G604T modem/router in DHCP mode?
1. Open your web browser
2. Open the link http://192.168.1.1/ from your browser. You will be prompted for username and password. If this is a new modem then following are the default username and password values.
Username: admin
Password: admin
3. Open "Setup" tab
4. Select "DHCP configuration"
5. Select "Enable DHCP Server"
6. Select "Apply"
7. Click the "Tools" tab. -> System Commands
8. Select "Save all" followed by "Restart"